This heat exchanger dwarf's the factory Shelby GT500 / Roush Magnacharger units and provides an over 160% cooling capacity increase in Shelby GT500 applications. This results in substancially reduced air inlet temperatures increasing supercharger power output under all conditions!
Our heat exchanger comes with all mounting hardware for installation on Shelby GT500 applications. Requires minor modifications for use on Magnacharger and Roush supercharged applications.
This unit installs in a GT 500 in about 4 1/2 hours and about 3 hours in a Roush.
Coolant Additive, Water Wetter, 12 fluid oz.
Red Line Water Wetter provides corrosion and rust protection for modern aluminum and cast iron cooling systems. This unique additive reduces coolant temperatures by as much as 30 degrees F. It can be used in plain water to provide much better heat transfer properties and protection than glycol-based antifreeze, or added to new or used antifreeze to fortify inhibitors and reduce foaming.
BBR S/C Pulley replaces your factory 2.93 pulley with our 2.57 pulley. This will increase your boost level from stock 5.5-6 psi to a new 7-9 psi.
Our Pulley is made highest Quality Billet Aluminum.
You will notice a huge increase in low to mid range HP & TQ.
We picked up 45 HP @ 4500 rpm
Note: Tuning is required
Also recommend is our 90mm Billet Idler pulley; this will help eliminate any belt slipage issues you may find with a smaller S/C pulley
***FYI: This pulley will NOT fit the 2009 Roush Supercharger***